MultiTek Transducer Trip Relay
| SELECTION GUIDE M200-TAU DC volts or mA under trip M200-TAO DC volts or mA over trip M200-TAC DC volts or mA combined trip TYPICAL APPLICATIONS The M200 DC transducer trips have endless applications. As the name implies they are designed to accept inputs from transducers and transmitters, and provide a relay operation when the transducer signal deviates outside a pre-set limit. Any of the M100 series transducers can be used with the transducer trip. A typical application is to control power using a M100-WA5 with a 4-20mA signal fed to a M200- TAO. For example the output goes above a pre-set limit of 80%, the TAO relay will close, setting off an alarm or shutting down a process. Either DC voltage or DC current inputs can be used. As is common with all the M200 relays, on over units the relay energises when the input signal exceeds the trip point and on under units the relay de-energises when the input signal goes below the trip point. A red LED indicates the state of the relay, while a green LED indicates the condition of the power supply. OPTIONS 1. Adjustable time delay max 30 seconds 2. AC auxiliary in the range 57.7 to 480 volts 3.Calibration at nominal Hz 35…..450Hz 4.Calibration at temperature other than 23º C |
TECHNICAL SPECIFICATION INPUT Rated value In 0<20mA or 4- 20mA Voltage drop 1 volt Rated value Un 1<50 volt or 1-5 volt Impedance 10k Ohm / Volt Overload 2xIn 1.5x Un continuous 10x In 2x Un for 3 seconds SETPOINT Range Over Adjustable 40% to 120% for both voltage and current input. Range Under Adjustable 0% to 80% for both voltage and current input. Repeatability Better than 0.5% of full span Time delay Adjustable 200 ms to 10 seconds Differential Fixed 5% AUXILIARY AC Voltage 115/230/400 V ± 25% / 45-65Hz / 2VA DC voltage 24 volt (± 20% / galvanically isolated) <3 watt WEIGHT & CASE SIZE Single units Approx. 0.4kg. 55mm case Combined unit Approx. 0.6 kg. 100mm case ORDERING INFORMATION Product Code Input Vn or In Aux Freq M200-TAC 1mA 110v 50Hz |